Title: Bottle door glass-81D
Post by: USMC Vet on May 18, 2007, 04:35:12 pm
I got my bottle door glass from Funtronics today.I have one easy question. One of the pieces of plexi is narrower than the glass or other piece of plexi. Could someone tell me what order they go from the front of the machine. Thanks. I also have the rubber gasket that goes somewhere in the puzzle.
Title: Bottle door glass-81D
Post by: Creighton on May 18, 2007, 06:20:54 pm
3 pieces? Do any have holes? As if you are looking at the machine:
1) Large piece (No Hole)
2) Small (If hole towards the bottom)
3) Large (If hole towards the botom)
The small piece goes in the middle so the door screws don't break it.
Creighton
1) Large piece (No Hole)
2) Small (If hole towards the bottom)
3) Large (If hole towards the botom)
The small piece goes in the middle so the door screws don't break it.
Creighton
Title: Bottle door glass-81D
Post by: USMC Vet on May 18, 2007, 06:47:07 pm
Yes,the 2 plexis have holes. The foam gasket goes between the glass and the 1st plexi?
Title: Bottle door glass-81D
Post by: sodaworks on May 19, 2007, 11:40:16 am
The small plexiglass panel mounts inside the gasket. The gasket will be sandwiched by the "outer" glass and the "inner" plexi glass panel, be sure that the vent holes are down and the handle is on as well. Tony, I am putting one of these together today as well. so if you need something ask away and I'll try to help you. 
Title: Bottle door glass-81D
Post by: davethebirdman on May 19, 2007, 12:25:54 pm
I had the same puzzle with my V-56. Phoned Steve and he sorted it out
just as Terry says.
Dave
just as Terry says.
Dave