|
Title: Bent coin release spring Post by: USMC Vet on April 25, 2007, 01:19:11 pm I am trying to put the bent coin release actuator spring back in and I am needing to know where the end of the spring hooks. I know the closed end hooks on the round tab on the actual coin door. I tried hooking it through the small hole next to where the actuator stud goes through but that makes the bottom of the coin release lever cock out. Does the hook goes towards the front of the machine or towards the back ? Thanks! 81D
Title: Bent coin release spring Post by: MoonDawg on April 25, 2007, 01:36:19 pm There is an L shaped bracket that screws onto the back of the
actuator that the spring hooks onto. Title: Bent coin release spring Post by: USMC Vet on April 25, 2007, 03:30:33 pm Thanks Glen, I got it working now. I had the darn bracket on upside down down. It works much better the correct way.
Title: Bent coin release spring Post by: sodaworks on April 25, 2007, 11:03:04 pm Tony,
Sounds like your getter pretty close with your machine. Can you share some photo's . Title: Bent coin release spring Post by: USMC Vet on April 26, 2007, 05:10:19 am I will take some photos today and post them before I go to work this evening. I tried posting some photos and it will only let me post up to 102400 bytes. Yes, I am getting pretty close to being done. I just ordered some final parts from Funtronics, Steve is a very professional and informative guy. I am getting ready to put new insulation in the door and get the rest of the door back together. I also have to put the refrigeration back in once I get the new power cord I ordered. I figured it would be easier to wire with the unit out. Other than those two tasks it's getting pretty close. Why are these machines so addictive ? LOL.
|