Title: V81 Bottle Door Glass
Post by: collecture on March 31, 2007, 10:58:38 pm
To make a long story short:
I accidentally busted the outer glass of my V81 bottle door.
Does anybody have the exact measurement of the glass?
It is running and I thought I could get a glass cut and replace it without shutting it down.
I thought all 3 pieces were glass, but it appears the inside two are plexiglass.
Anyway, any help is appreciated.
I accidentally busted the outer glass of my V81 bottle door.
Does anybody have the exact measurement of the glass?
It is running and I thought I could get a glass cut and replace it without shutting it down.
I thought all 3 pieces were glass, but it appears the inside two are plexiglass.
Anyway, any help is appreciated.
Title: V81 Bottle Door Glass
Post by: MoonDawg on April 01, 2007, 10:31:44 am
Outer and inner panels measure 30 1/2" X 5 1/4".
Inner 29 1/8" X 3 7/8".
Have all 3 cut from glass...the viewing area becomes
so much clearer with the aid of that light. Drilling holes
in two inner panels seems optional.
Inner 29 1/8" X 3 7/8".
Have all 3 cut from glass...the viewing area becomes
so much clearer with the aid of that light. Drilling holes
in two inner panels seems optional.
Title: V81 Bottle Door Glass
Post by: collecture on April 01, 2007, 12:25:38 pm
Thanks Glen!
Were the two inner panels originally plexiglass on all 81A's?
Has mine been replaced with plexiglass at some point?
Since my 81 is original, I would prefer to keep it as close as possible to what it was from the factory.
My inner panels are not bad, but I will see if I can buff out a few of the small scratches -
Since I will have it open.
If they were originally glass, I will have new panels with holes cut.
Were the two inner panels originally plexiglass on all 81A's?
Has mine been replaced with plexiglass at some point?
Since my 81 is original, I would prefer to keep it as close as possible to what it was from the factory.
My inner panels are not bad, but I will see if I can buff out a few of the small scratches -
Since I will have it open.
If they were originally glass, I will have new panels with holes cut.