|
Title: Crank Handle won't return. Post by: davethebirdman on December 14, 2006, 10:52:44 am Okay Guys
need your help once again. Remember you need to spell it out nice and slow for me. The crank handle on my 56 will not return. I ordered a new spring from Steve at Funtroincs and it arrived a while ago. I am currently off work with the Flu and looking after two kids one with chicken pox and a virus the other just got over chicken pox but milking his virus. So not a good day to take apart a coin mech. Never the less that is exactly what I did. I took apart the coin mech remving ALL those screws gaining access to that spring. I replaced it and managed after swearing at the dog to get it all back together again, with no leftover screws. However, it still doesn't return. Can anyone throw some light on this little problem of mine. Iwas thinking that I might not have wound the spring tight enough but I've looked at the 39 and it seems just the same as the 56. Dave Title: Crank Handle won't return. Post by: collecture on December 14, 2006, 12:52:24 pm Dave,
You need to: 1. Make sure that the spring is connected to both the shaft and the mech housing. 2. When you wind the spring, the shaft needs to be rotated clockwise on a small door mech (large door straight sale actuator)about one full turn. The nickel and dime slots should be on top when you slip the back cover over the shaft. You have to hold the shaft to keep it from flipping back while you put the back plate on - you will be able to sort of rest it on the front cover, but don't trust it fully and keep pressure on the shaft. I usually grease the spring - install it - then grab my hand over the front to hold the shaft in place - slip it down over the back cover - make sure the ratchet pin and dog shaft stick through the front cover and then install a screw on each side loosely. Then you can get the rest of it put together and tighten all screws. It is hard to explain, but I hope it makes sense. If you are still having problems, I'll break one down, take some pictures and detail them for you this weekend. Title: Crank Handle won't return. Post by: davethebirdman on December 14, 2006, 01:10:38 pm Hi Tom
I'm going to print your instructions out and follow them step by step with the blasted thing infront of me. Thanks Dave Title: Crank Handle won't return. Post by: davethebirdman on December 17, 2006, 07:06:28 am Hi Tom
My internet is down so can't send E-mail. Just a very quick thank you. Took the coin mech to my father's house last night and we managed to get it working better than ever, due to your comprehensive instructions. Dave Title: Crank Handle won't return. Post by: collecture on December 17, 2006, 09:19:33 am That's great Dave!
Now before you put it back in the machine, put a little grease on the shaft teeth that the ratchet locks on. Easy to get to from the bottom when it is in the ready to vend mode. We want to see more pictures and I'm glad you changed the 56 description in your signature. |