Title: Vendo
Post by: on January 19, 2006, 10:13:03 am
i just bought a vendo model number h1263 and it will not cool does anyone have any trouble shooting tips i can try ?the bower is working but no cold air ....i was thinking the compressor ..since it doesnt click on ...any help would be helpfull
travis
travis
Title: Vendo
Post by: Kevin C on January 19, 2006, 02:38:37 pm
Hello
Can you post a picture of your machine?
First I would try plugging the compressor directly in with an extension cord. Let it run for a few minutes & then check the upper coil for frosting. If this works then you have an electrical problem if this does not work ( compressor not running) you most likely have refrigeration issues.
Kevin
Can you post a picture of your machine?
First I would try plugging the compressor directly in with an extension cord. Let it run for a few minutes & then check the upper coil for frosting. If this works then you have an electrical problem if this does not work ( compressor not running) you most likely have refrigeration issues.
Kevin
Title: Vendo
Post by: on January 19, 2006, 06:18:25 pm
Hey I tried it and it started cooling so ...that's good news, I was told I need a 3 in 1 starter relay anyone have any ideas?
Travis
Travis
Title: Vendo
Post by: johnieG on January 19, 2006, 06:52:25 pm
Well, if the compressor started up OK with the extention cord, the good news is that you won't need a 3-in-1 starter/booster! the bad news is that somethings not allowing the compressor to start normally (when it's pluged into its power socket on the wiring harness) I'd start by unpluging the machine, remove the wires from the Thermostat & connect them together temporarily with a jumper wire & electrical tape. then plug the compressor back into the socket down below (on the wiring harness, that is) & plug the machine in...now if the compressor comes to lif, then it's simply a bad thermostat, if not , you'll have to start digging a little deeper into the wiring harness...we'll start here & see where it gets you...here's a basic wiring diagram of what you're working on...hope it helps
Title: Vendo
Post by: Kevin C on January 19, 2006, 10:22:57 pm
Hey
If it worked on the extension cord. Go to Soda Jerk & buy a new wiring harness.
Kevin
If it worked on the extension cord. Go to Soda Jerk & buy a new wiring harness.
Kevin
Title: Vendo
Post by: on January 20, 2006, 04:42:42 am
ill look into a harness but can you explain to me were the thermostat is 
?seems simple fan works ,compressor works just got to get them to work together ....thanks travis
?seems simple fan works ,compressor works just got to get them to work together ....thanks travisTitle: Vendo
Post by: on January 20, 2006, 04:48:40 am
also what harness wil i need ???ill post picks later today of the hole thing thanks travis
Title: Vendo
Post by: on January 22, 2006, 01:29:31 pm
ok i jumped the thermostat and the compressor didnt kick on so im going to assume i need a harness .....i hope that will do it
Title: Vendo
Post by: zadd on February 11, 2006, 02:19:15 pm
You might have a vendo h126b Usually the wiring harness will do the trick,those machines are pretty much bulletproof. I have two and they work great after cleaning and new fans,wiring harness.
Usually the wiring harness will do the trick,those machines are pretty much bulletproof. I have two and they work great after cleaning and new fans,wiring harness.