Title: Jumper?
Post by: Pixel on January 06, 2006, 08:04:51 pm
In my Choice Vend, in the lower compartment, to the right of the compressor deck, I have a black terminal which I believe is where the power cord plugs into the machine. On that same terminal above the power cord, there is a short loop of stiff wire covered in red insulation-the wire appears to be at least 1/8" thick.
The wiring diagram seems to indicate this is some sort of jumper for the defrost system, but I'm not sure. The ends of the loop make a plug.
When the machine is operating normally, should this jumper be plugged in? What's it for?
Thanks.
The wiring diagram seems to indicate this is some sort of jumper for the defrost system, but I'm not sure. The ends of the loop make a plug.
When the machine is operating normally, should this jumper be plugged in? What's it for?
Thanks.
Title: Jumper?
Post by: johnieG on January 08, 2006, 03:42:01 pm
It's been a while since I sold my Choicevend, but as I recall, the jumper should remain connected, & only removed to plug in the optional defrost option, if it doesn't have one , don't "sweat it" (bad pun) 