Title: Anybody know about these hinges?
Post by: Bob K on July 04, 2005, 12:51:22 pm
Hi,
I'm assembling my Standard Top and I don't know how these hinge tabs are supposed to be installed (or what their function is...
)
Are they supposed to be flat? One was flat and the other was bent at 90 degrees as pictured below.
If anyone has a machine with this type hinge and could supply a picture, I would be eternally grateful
. You can see at the bottom of the picture where it gets installed.
Here's what I'm talking about:
Thanks,
Bob
I'm assembling my Standard Top and I don't know how these hinge tabs are supposed to be installed (or what their function is...
)Are they supposed to be flat? One was flat and the other was bent at 90 degrees as pictured below.
If anyone has a machine with this type hinge and could supply a picture, I would be eternally grateful
. You can see at the bottom of the picture where it gets installed.Here's what I'm talking about:
Thanks,
Bob
Title: Anybody know about these hinges?
Post by: Kilroy on July 04, 2005, 01:54:03 pm
Bob, my Junior is still in the partially dismantled phase, so I'll keep an eye out, and snap some pics, I don't know how major the differences are between a junior and standard (besides the fact the cooler is larger)
Is there a pin in the hinge? If the body panel pic is one of the sides, maybe it locks the compressor grate cover in place?
Is there a pin in the hinge? If the body panel pic is one of the sides, maybe it locks the compressor grate cover in place?