SMC Discussion Areas

Added my first Stoner to the collection and had a few questions I hope you all can help with

1) how do I set to free vend (have only seen how to do on a 120)
2) what are the latch like thinks on the bottom (2nd pic)

Thanks in advance

Congrats !!

First is the coin mech present ? If so there should be a small lever on the left side with like a piece of spring steel on it just pull it out .or remove the coin mech
Second those are the levers on the base to level the machine or cause a slight lean backward so it doesn't lean while pulling knob . There's a flat head Setscrew in the hole there the front . 99% of the time there sesed up I usely have to heat them up with a propane touch to get them our  and even in worst case drill them out

Thanks will give that a try. The "feet" look like latches and wasn't about to go pulling on them. Thanks again

I have never messed with the feet but I always thought that those allowed the machine to self-level.

 :drinking: Tim :drinking:

Hey Tim

You have about a 3/4 -1 inch set screw that in there to level the machine I tilt mine back a little as it's seems when you pull the knob they have a tendency to lean forward .