|
Title: Wooden Spacer / Main Door Vendo 56 Post by: Slapshot42 on July 06, 2017, 12:01:09 am My hardware kit is calling for a wooden spacer between the main door and liner??? I don't remember a wooden spacer ??? Can someone assist? Is this critical to install the liner without the spacer?
I did not see the wooden spacer in the service manual. Thx Title: Re: Wooden Spacer / Main Door Vendo 56 Post by: Jim on July 06, 2017, 06:51:09 am Tank Liner Spacer (http://sodajerkworks.com/onlinepartscatalog/hard-parts/hp121b-1-4-tank-liner-spacer-detail)
Title: Re: Wooden Spacer / Main Door Vendo 56 Post by: Slapshot42 on July 06, 2017, 09:00:31 am I noticed that but the description excludes the Vendo 56. Also
the description on the hardware list says; " Wooden Spacer, main door to liner". Title: Re: Wooden Spacer / Main Door Vendo 56 Post by: MoonDawg on July 06, 2017, 10:31:18 am There is a wooden spacer that goes around the coin mech. shaft. It looks identical to the 3 spacers found in 33's.
Title: Re: Wooden Spacer / Main Door Vendo 56 Post by: Slapshot42 on July 06, 2017, 04:09:44 pm There is a wooden spacer that goes around the coin mech. shaft. It looks identical to the 3 spacers found in 33's. Will this work Glen? http://sodajerkworks.com/onlinepartscatalog/hard-parts/hp121-vendorlator-spacers-detail Title: Re: Wooden Spacer / Main Door Vendo 56 Post by: SIGNGUY on July 06, 2017, 04:20:44 pm Funtronics nor soda jerk works sells one specifically for the Vendo 56..but this one pictured might work if the measurements are right.. but I measured it and ended up making one out of a block of wood... it does not have to be round, just the hole has to be large enough for the vend shaft to go through.. I think it was 5/8.
if I recall it's only 1 1/2 inches deep.. Title: Re: Wooden Spacer / Main Door Vendo 56 Post by: Slapshot42 on July 06, 2017, 04:52:11 pm Funtronics nor soda jerk works sells one specifically for the Vendo 56..but this one pictured might work if the measurements are right.. but I measured it and ended up making one out of a block of wood... it does not have to be round, just the hole has to be large enough for the vend shaft to go through.. I think it was 5/8. if I recall it's only 1 1/2 inches deep.. Thanks th one from SJW is as follows; 1.5 L - od 1-7/16 – id 1/2" Title: Re: Wooden Spacer / Main Door Vendo 56 Post by: SIGNGUY on July 07, 2017, 08:24:11 am that one should work then,, the ID hole may have to be bored out a bit, as I think I tried 1/2 as well and was a very tight fit, so went with 5/8
hopefully Jebb will add that to his V56 parts list... Title: Re: Wooden Spacer / Main Door Vendo 56 Post by: Slapshot42 on July 08, 2017, 08:07:17 pm Here is the original one. The newer one is is pictured left which is sold by SJW for the VMC 33. The blocks are the same outside diameter but the shaft hole is smaller on the 33 block and it's slightly less in overall height .
|