|
Title: Quickcold Lower End Cap and Frame Needed. Post by: ajf5577 on November 21, 2015, 02:55:53 pm Does anyone have a junk standard or master with an end that has "Ice Cold" ? I just need the lower half with the words on it. The one that I have has damage. Doesn't matter what brand of soda. I Also need the lower frame. Condition needs to be good enough to restore.
Title: Re: Quickcold Lower End Cap and Frame Needed. Post by: ld26 on November 21, 2015, 07:03:39 pm Sorry don't have a donor side but before you get one measure the width of that side panel, it should be 23 inches wide to match a standard size side panel, just to be sure, I usually know it will be good by seeing the 5 grooves on the bottom of the side panel, from the picture I can't tell
Title: Re: Quickcold Lower End Cap and Frame Needed. Post by: Eric on November 21, 2015, 07:24:37 pm No extras here either... If you're going to make it a standard or junior it'll need these 5 indents along the bottom like ld56 posted.
If it has 4 it's a larger style and would be too wide for these models. All your embossing looks good is the ICE COLD bad? Could always cut all the embossing out and place on a generic cooler if you find one that doesn't have the ICE COLD... Title: Re: Quickcold Lower End Cap and Frame Needed. Post by: ajf5577 on November 21, 2015, 09:03:11 pm Good points. I will have to get it out and look at it again.
The " ice cold" is good. Just has that tear on the edge, and the bottom corner is a little soft. I'm sure a good body man can fix the tear. |