|
Title: Westinghouse Master Agitator impeller Post by: First Timer on August 07, 2014, 08:50:55 am Can anyone point me in a direction as to where to find an impeller for the agitator. My agitator works fine just no impeller.......
Any help would be greatly appreciated. DP Title: Re: Westinghouse Master Agitator impeller Post by: johnieG on August 07, 2014, 12:32:44 pm Both Funtronics & SodaJerkWerks offer replacement motors & impellers, however their replacement impellers may not fit your OEM motors shaft.
Title: Re: Westinghouse Master Agitator impeller Post by: First Timer on August 07, 2014, 12:40:08 pm Thanks for the reply. I will contact them and see. I have seen the motor replacement. Just not the impeller by itself.
Maybe it will be such that I can modify one or the other to make it work. DP Title: Re: Westinghouse Master Agitator impeller Post by: Jim on August 07, 2014, 08:48:17 pm If nobody sells the impeller separately, let me know as I have an extra impeller from a recent project...
Title: Re: Westinghouse Master Agitator impeller Post by: Blind1968 on August 08, 2014, 03:38:05 am If someone has one off or out of the machine and could post a pic of it for you to see. There is not much to it and could be fabricated fairly easily.
Title: Re: Westinghouse Master Agitator impeller Post by: First Timer on August 08, 2014, 09:04:31 am I might take you up on your offer.
If I could get a pic it would help. At least I would know what I'm looking for. Title: Re: Westinghouse Master Agitator impeller Post by: First Timer on August 09, 2014, 02:29:40 pm Jim,
Would you be willing to sell me the one you were referring to? Just let me know. Thanks DP Title: Re: Westinghouse Master Agitator impeller Post by: Jim on August 09, 2014, 04:46:24 pm DP,
Here a few photos of the impeller... It is for a 1/4" shaft and is 2" dia. Let me know if this will fit your needs and please double check diameters to ensure proper clearances! Title: Re: Westinghouse Master Agitator impeller Post by: First Timer on August 09, 2014, 05:10:54 pm Jim
I believe that will work. The end of my shaft is 1/4 20 threaded with a flat side on the shaft. When assembled the shaft is approx 1/2" or more below my evaporator. So I should have plenty clearance. DP |