|
Title: Not making waves Post by: Pope on September 16, 2013, 06:24:47 pm Hi,
In the middle of refinishing the cabinet from a VMC 110. The side and back panels are not dented, but have a little wave in them over the top to bottom. The metal can be pushed in a little and it springs back, which I assume is normal in the design of these machines without much bracing. How straight do you guys get the panels? It's not like a cars body that you have to get perfectly straight, or is it? I am getting it as straight as possible, but what do you guys try to achieve. Thanks Gary Title: Re: Not making waves Post by: Slider-Bob on September 16, 2013, 06:28:16 pm Hi Gary. PM sent.
|