|
Title: Coinco 903030 Post by: Norrisk66 on August 21, 2013, 02:46:15 pm Hi, coin mech is set at 50 cents. When a quarter is inserted, it drops right into the coin return.
I think I have traced the problem to the upper solenoid. It has a plastic arm on it that says "do not remove" I can tape the arm in, and when I put a quarter in, it goes where it should. The solenoid ohms at 1.731K Ohms. It is not open, but I am thinking that it is not "sucking" the solenoid in? My next step is to check power-should this solenoid have power on it at all times? Thanks! Keith Title: Re: Coinco 903030 Post by: tkaz on August 21, 2013, 03:13:01 pm Do you have the change hoppers filled up with change and/or product in the machine? What machine is the mech in?
Title: Re: Coinco 903030 Post by: Rebel on August 21, 2013, 10:28:21 pm I think I may have just the opposite going on. When I plug coin mech in, I hear the solenoids activate and don't release but stay in. When I remove top and drop a coin in goes to the right to coin hoppers but on machine,,the coin goes to left to return slot. I'll be watching for sure.
Title: Re: Coinco 903030 Post by: Norrisk66 on August 22, 2013, 07:22:47 am Both change hoppers are about 1/4 full of nickels.
I think it is a Vendo 52? From what I can make of the tag-it says V52H-304 Title: Re: Coinco 903030 Post by: Norrisk66 on August 22, 2013, 12:58:11 pm Correction-It is a Vendo V528-304.
|