SMC Discussion Areas

Soda Machines, Coolers & Dispensers => Pre 60's Machines & Coolers => Topic started by: toolbox on May 06, 2013, 01:59:06 pm



Title: Test post has been erased by toolbox
Post by: toolbox on May 06, 2013, 01:59:06 pm
THIS IS JUST ANOTHER TEST. I'm a slow learner.


Title: Re: Test post for I.D.ing pre-1960 Vendo machines
Post by: jholmgren on May 06, 2013, 02:33:34 pm
Hi Ted,
I have a very nice original (except for cooling system) V59 if you need any data or pictures.

Regards,
Jim


Title: Re: Test post for I.D.ing pre-1960 Vendo machines
Post by: toolbox on May 08, 2013, 06:48:11 pm
Thanks much Jim,
You bet, I could use pics, especially of the Vendo model number plate & where its located. I haven't seen one yet posted anywhere.
Also, if there's a plate I.D.ing the manufacturer of the chest I'd like a pic. I'm wondering if Vendo sub-contracted the chest.
A general overall shot would be nice too.
I appreciate your effort.
Ted


Title: Re: Test post for I.D.ing pre-1960 Vendo machines
Post by: johnieG on May 08, 2013, 07:17:33 pm
Sounds like an interesting endeavor. There's always been a bit of confusion with the spin-tops.


PS...I'd think I'd personally rather be referred to as a "site member" not a "viewer" as it sounds to passive to me.


Title: Re: Test post for I.D.ing pre-1960 Vendo machines
Post by: toolbox on May 09, 2013, 05:12:28 pm
Point well taken johnieG. I made the correction. Its got to be frustrating watching out over all of us Newbie's, ha?
Have a good one.


Title: Re: Test post for I.D.ing pre-1960 Vendo machines
Post by: Creighton on May 09, 2013, 07:59:11 pm
Good for you for taking on a needed task.
Have spent many years swearing and flipping off Excel (to no avail). What needs tested?
Might be able to help with that.
Have since moved on to Open Office but don't see any issues with compatibility.
Creighton


Title: Re: UPDATE Test post for I.D.ing pre-1960 Vendo machines
Post by: toolbox on May 19, 2013, 11:27:29 am
MOVING BACK TO THE TOP