SMC Discussion Areas

The Vending Rack => Swap Meet Area => Topic started by: BeaYoung on April 30, 2013, 08:42:00 pm



Title: Narco CL-50B 3 Door Cooler
Post by: BeaYoung on April 30, 2013, 08:42:00 pm
Hi! I am listing this machine for a friend. I don't know lots about it other than it is in the Milwaukee area. My friend Paul was going to make a Coke Counter Bar in his rec room with it and then changed his mind. He is looking for $500/offer. PM me and I'll send you his email address. Thanks!



Title: Re: Cavalier C-31 3 Door Cooler
Post by: Slider-Bob on April 30, 2013, 08:48:07 pm
I think its a Victor c-31, not a Cavalier, but I may be wrong.


Title: Re: Cavalier C-31 3 Door Cooler
Post by: MoonDawg on April 30, 2013, 08:53:06 pm
      It's a Narco cooler.


Title: Re: Cavalier C-31 3 Door Cooler
Post by: mznb1u on April 30, 2013, 08:55:23 pm
If it is a C-31 it would be a Victor; however, those smooth doors make me think it is a Narco CL-35B.  I have never seen a Victor that did not have the corrugated roll-up doors but I am sure somebody will correct me if I am wrong.

Nice cooler and I might even consider it if I did not already have a Victor C-45.

 :drinking: Tim :drinking:


Title: Re: Cavalier C-31 3 Door Cooler
Post by: Slider-Bob on April 30, 2013, 08:55:46 pm
Thanks Glen/Tim...I knew it wasn't a Cav, but without the accordion doors, it didn't look like a correct victor. mystery solved.


Title: Re: Victor C-31 3 Door Cooler
Post by: mznb1u on April 30, 2013, 08:56:53 pm
Damn!  Glen beat me to the punch! :biggrin:

 :drinking: Tim :drinking:


Title: Re: Victor or Narco C-31 3 Door Cooler
Post by: BeaYoung on April 30, 2013, 08:58:11 pm
Thanks guys... I updated the description. I found it in the Walters book too.. Was just looking in the wrong spot.

B.


Title: Re: Victor or Narco C-31 3 Door Cooler
Post by: kbareit on April 30, 2013, 09:01:53 pm
I already have the C-31, think I'll pass on this one.


Title: Re: Narco CL-50B 3 Door Cooler
Post by: BeaYoung on April 30, 2013, 09:05:30 pm
If a person had the right spot, I could see where it would make a nice bar...