|
Title: the heat is on! Post by: globalcompressors on June 11, 2012, 02:20:03 pm cranking em' out....
Title: Re: the heat is on! Post by: Larry on June 11, 2012, 02:38:23 pm Keep on cranking!
What does a condensing unit go for? Title: Re: the heat is on! Post by: globalcompressors on June 11, 2012, 02:43:15 pm Keep on cranking! What does a condensing unit go for? PM me, and we'll figure out what you need. Title: Re: the heat is on! Post by: jholmgren on June 11, 2012, 02:49:02 pm With all that heating/cooling going on in that room if you ran them all at the same time you'd have thunderstorms in the room! :tounge:
Title: Re: the heat is on! Post by: briandr1 on June 11, 2012, 04:43:56 pm Very nice looking and great job with the copper lines.
Title: Re: the heat is on! Post by: globalcompressors on June 11, 2012, 04:50:24 pm as always, everything is done by hand. sharp, clean bends are key to a good looking "unit" ... :Oo:
Title: Re: the heat is on! Post by: johnieG on June 11, 2012, 06:34:07 pm Very nice indeed! :drinking:
Title: Re: the heat is on! Post by: Creighton on June 11, 2012, 08:47:17 pm Cool stuff Eric, Ship them decks and get yourself a 2013 GT-500 :-)
Creighton Title: Re: the heat is on! Post by: tkaz on June 11, 2012, 08:55:06 pm Those look great...one of these days I'll have a machine nice enough to put one in!
Title: Re: the heat is on! Post by: Pat Pixley on June 11, 2012, 09:40:12 pm There set alot of money, looks good Eric
Title: Re: the heat is on! Post by: globalcompressors on June 12, 2012, 06:36:09 am a lot of work goes into these for sure!
|