|
Title: Replacing a door liner with an aluminum sheet Post by: tkaz on March 25, 2012, 08:38:24 pm Has anyone replace the plastic door liner with an aluminum or thin steel sheet? The liner on a couple of my USS machines is some form of aluminum, looks a lot like that white composite board you can buy at home depot with lots of dimples on it...any ideas on where to start? I should be able to cut a new one without any issues, just trying to figure out what material might work the best on it.
Title: Re: Replacing a door liner with an aluminum sheet Post by: Tay on April 03, 2012, 11:04:14 pm when i did one of mine i just used galvanized sheet metal. the hardest part is rolling the bottom (where the power and cooling lines run through)
|