|
Title: Crank Handle Spring Post by: vendo39 on March 06, 2012, 09:48:16 am I’m finally reassembling a Vendo 56 after a long delay and last night I discovered I’m missing one of the two spring rests (pictured as part #'s 81 & 83 in the attached picture). Will the crank work without one of the rests or do I need to fabricate one up to have any chance of the crank working?
Thanks Title: Re: Crank Handle Spring Post by: SIGNGUY on March 06, 2012, 09:50:56 am they are there to provide extra tension to the spring... I've seen some that only have 1 in them, and have reassembled them the same and they work well.
Title: Re: Crank Handle Spring Post by: KennyG on March 06, 2012, 10:56:07 am My 81 only had 1 and it works.
Title: Re: Crank Handle Spring Post by: vendo39 on March 06, 2012, 11:06:13 am Thanks! :biggrin: Going with one! Assuming it doesn't go flying off into some dark corner of the shop never to be found again during reassembly!
Title: Re: Crank Handle Spring Post by: Jim on March 06, 2012, 03:12:35 pm And for assistance if needed, you can read this posy in Tutorials & Tips:
Crank Handle Re-Assembly (http://soda-machines.com/discussions/index.php/topic,7473.0.html) |