SMC Discussion Areas

Restorations => General => Topic started by: fabes on November 01, 2011, 01:34:15 pm



Title: Moving machine
Post by: fabes on November 01, 2011, 01:34:15 pm
Hey fellas, I'm finishing up my 6 case and I had a question about moving it....

I'm moving it into my office, the machine is on wheel casters. My question is that after I roll it from my garage to my office (about 30 feet), should I let it sit for 24 hours before I turn it on? I have to move the machine over a few door frame bumps, but other then that, its a pretty smooth ride to the office.

Thanks



Title: Re: Moving machine
Post by: Jim on November 01, 2011, 01:57:26 pm
If you keep the machine upright for the move, you should be good to go and plug it in! Tilting the machine a little while on a dolly/hand truck ride isn't going to affect anything.