|
Title: Vendo 63 Door Liner Clips Post by: Jacko1070 on July 06, 2011, 08:30:34 am Hello all........
Ready to start my tear down and I was wondering if anyone had a helpful hint on removing the door liner clips for a vendo 63. Done some looking around and at roughly a buck a piece, I want to try and salvage as many of these as I can and not destroy them removing them. Is there a good method to release the clip and keep it usable? Title: Re: Vendo 63 Door Liner Clips Post by: TMC on July 19, 2011, 11:31:50 am I used a needle nose to pull out enough to get a small flat head in between the clips then pryed slowly. I Did not break any.
Title: Re: Vendo 63 Door Liner Clips Post by: Jacko1070 on July 19, 2011, 12:01:12 pm Thanks, wasn't sure how brittle they are and usually anything with a "pop" center breaks when removing. I appreciate the info
Title: Re: Vendo 63 Door Liner Clips Post by: TMC on July 19, 2011, 01:01:27 pm Mine were in good shape so I make no promises with yours I do have some extra of both sizes if you break any.
Title: Re: Vendo 63 Door Liner Clips Post by: Jacko1070 on July 19, 2011, 02:01:47 pm I'll keep it in mind.....thanks again!! Your machine came out very nice, by the way
Title: Re: Vendo 63 Door Liner Clips Post by: johnieG on July 19, 2011, 05:27:02 pm TIP...Once you get them out of the machine & you wish to re-use them, be aware that if you try to bend the "wings" they will snap off!...so hold them in a pair of needle nose piers & heat them in the middle ( where the clips are bend from removing them) with your propane torch until it glows dull-red, now let them cool slowly out of the way, & it will make them malleable enough to reshape them so they will once again retain themselves & the liner to the door.
|