|
Title: 81a motor question Post by: smith on May 17, 2011, 12:55:19 pm The 1/4 motor that sits on the bottom, is the motor a seal unit. I am trying to re wire it. there is a small Phillip screw I took out,
but have no idea what it does. I try a cloth with chandler locks but will not budge. Any suggestions? Thanks Mike Title: Re: 81a motor question Post by: collecture on May 17, 2011, 01:32:54 pm Got a picture? Most all of the 81 compressors were sealed units I think.
There is a cover screw and I think two screws underneath the cover that hold the relay and overload protector. Not sure exactly what you are referring to. Title: Re: 81a motor question Post by: smith on May 17, 2011, 05:37:47 pm Collecture, it is the evaporator fan, is it a seal unit? Thanks Mike
Title: Re: 81a motor question Post by: collecture on May 17, 2011, 06:26:16 pm If I am reading this correctly...I think it might be an oiling point that you're inquiring about??
Title: Re: 81a motor question Post by: smith on May 17, 2011, 07:36:59 pm I just wondering if the back will come off the motor so I can rewire it. It worked good before restoration, or do you think I should just replace while
I have it torn down? Thanks Mike Title: Re: 81a motor question Post by: collecture on May 17, 2011, 07:43:08 pm I'd just replace it - no worries for years to come!
Title: Re: 81a motor question Post by: coke_and_stuff on May 17, 2011, 09:39:25 pm Motors are cheap just replace it.
Joey Title: Re: 81a motor question Post by: smith on May 17, 2011, 10:03:30 pm Thanks thats what I will do. Mike
|