|
Title: CSS-8-64 Post by: perhoades on April 22, 2011, 10:42:08 pm Hi,
I have a CSS-8-64 machine that I purchased about a year ago that I am just now getting able to work on. I have replaced the thermostat control and am in the process of cleaning it out. The main reason I am posting to this forum is that the Coin Mech/Vendor/Change giver isn't functioning properly. I have gathered that it is a National Rejector model 8000 or series 1-15 setup. The problem is that once the machine is plugged in the change unit just runs ands runs and runs. I load nickels and dimes into it and it just spits them out. Any ideas what the problem(s) could be? Title: Re: CSS-8-64 Post by: johnieG on April 22, 2011, 11:00:13 pm first suspect is a stuck/shorted or reverse-wired inventory/change switch, it's used to manually eject coins from the change tubes for inventory, ( as the name suggests). The switch is usually a small sliding type mounted on the front lower corners of the mechanism.
You can see the inventory switch on the attached picture, it's on the lower-right corner on this Coinco 9800 series mech' Title: Re: CSS-8-64 Post by: perhoades on April 23, 2011, 04:41:54 am Here is a picture of the coin unit. Let me know if you need others.
Title: Re: CSS-8-64 Post by: johnieG on April 23, 2011, 10:11:00 am Your inventory switch is the small red slider I circled in your picture, make sure it's not set to eject all of the change.
|