SMC Discussion Areas

Trouble-Shooting => Refrigeration => Topic started by: brodiew on June 26, 2010, 10:25:25 pm



Title: Dixie Narco 180 Evap fan
Post by: brodiew on June 26, 2010, 10:25:25 pm
While I was away, my daughter heard an awful noise coming from the machine and unplugged it.  When I got back I plugged it in and all was good.   About a week later, I was away again and now my son hears it and unplugs it.  Again, I plug it in no problems until yesterday.  Was hearing a thumping type sound and I figured out ( at least I think I did) that it was the evap fan making the racket!  I managed to get the thing out, but it looks OLD.  I would like to get a replacement, but not sure of the best place to look.  Seems the last sites that were recommend to me no longer have web sites. 

Any ideas??


Title: Re: Dixie Narco 180 Evap fan
Post by: JBVending on June 27, 2010, 11:20:26 am
Could it have been ice build up on evaporator coil and hitting fan blade? That may explain why it runs for a time before it makes noise.

JB


Title: Re: Dixie Narco 180 Evap fan
Post by: johnieG on June 27, 2010, 12:11:21 pm
try grainger's website, it's called a unit-bearing motor, just match the speed ( usually 1550 rpm) & watts
( usually 6-15 watts ) & the rotation ( marked on your motors end-cap CW=clockwise CCW=counterclockwise, also note that most motors of this type indicate rotation as viewed from the shaft-end as you look at the fan blades, but some refer to the lead-end as viewed from the rear of the motor were the wire-leads enter it) if you give them the part no. off of you motor, they should be able to cross-reference it.   yours says 6-Watts, 1550 RPM, CW you can go a little higher in watts, but not RPM, make SURE of the rotation, (they don't work backwards & you can't just reverse the fan blades either.

http://www.grainger.com/Grainger/unit-bearing-motors/hvac-motors/motors/ecatalog/N-9yd?op=search (http://www.grainger.com/Grainger/unit-bearing-motors/hvac-motors/motors/ecatalog/N-9yd?op=search)


Title: Re: Dixie Narco 180 Evap fan
Post by: brodiew on June 27, 2010, 01:07:23 pm
@ JBVending - I did not see any ice on the coils, but then again, I did not look too hard either.  Might have to clean the fan up, reinstall it and do a check when it happens again. 

@ johnieG - Thanks for the Grainger idea and website link.  Looks like I will have no problem replacing the fan if is indeed faulty.

Thanks to both of you for the help!

Bill


Title: Re: Dixie Narco 180 Evap fan
Post by: johnieG on June 27, 2010, 04:13:28 pm
No prob', when these fan motors ( unit-bearing design) go bad, the axle/shaft will "walk" in 7 out of the motor bode, they always have some horizontal play to them, but anything over abut 1/4" is excessive and it will cause the fan to strike & "screech" across the backside of the evaporator fins, or the motor bearings themselves will "howl" ...It's more critical up near the evaporator as opposed to the condenser as the fan is usually quite close to the fins up there.