Title: Cavalier 22 hinge need input
Post by: jasmine64 on August 12, 2005, 09:50:15 am
Ok, I have been trying to loosen the screws on the hinges of my Cavalier 22 lids. To get to the rusted places so I can fix them.
Has anyone got the foggiest ides if there is a nut on the screw (inside the lid liner) or what. I have even tried to get the pin out of the hinge but I cant.
Who has had luck removing the hinges on these machines.
I'll have to remove the liner to find out. Going to replace the liner anyway through Funtronics.
Need input.
Has anyone got the foggiest ides if there is a nut on the screw (inside the lid liner) or what. I have even tried to get the pin out of the hinge but I cant.
Who has had luck removing the hinges on these machines.
I'll have to remove the liner to find out. Going to replace the liner anyway through Funtronics.
Need input.
Title: Cavalier 22 hinge need input
Post by: sodaworks on August 12, 2005, 12:47:29 pm
Your best bet is to remove the liner, it should have about 10 screws holding it in place. 