|
Title: Advice on cleaning galvanized liner and bottle rack. Post by: Ezra on September 27, 2014, 09:04:19 am I want to leave the inner cabinet, components, and door original unpainted galvanized, Cav 72. What would you recommend on how to give the metal a new/ish look. Is there a chemical cleaner? Maybe soda blasting very mild abrasive that wont effect the galvanized coating?
Thank You Title: Re: Advice on cleaning galvanized liner and bottle rack. Post by: sodaworks on September 27, 2014, 09:46:20 am SOS pads works
Title: Re: Advice on cleaning galvanized liner and bottle rack. Post by: georgescustompaint on September 27, 2014, 12:32:05 pm CLR cleaner works great with a fine scrub pad
Title: Re: Advice on cleaning galvanized liner and bottle rack. Post by: Slapshot42 on September 27, 2014, 03:26:59 pm The liners come out real easy.
I would have it powdercoated will hold up for many years of use! SOS pads work too!! http://soda-machines.com/discussions/index.php/topic,15792.0.html Title: Re: Advice on cleaning galvanized liner and bottle rack. Post by: Creighton on September 27, 2014, 04:43:46 pm Welcome to the board.
I would start with a few nylon brush's and boiling hot water with a bit of Dawn dishwashing liqued tossed in. SOS pads can cause scratching. CLR if left on too long will eat the galvi platiing right off. Should clean up fine. Unless machine will be in a heavy use area I have never seen the need for the expense of powdercoating. Creighton Title: Re: Advice on cleaning galvanized liner and bottle rack. Post by: kdog on September 09, 2018, 02:23:06 am What about using a Automotive Wash & Wax soap? If its good enough not to strip off the paint on your car, and then protect it, is it ok to use on the galvanized inside of a machine?
Title: Re: Advice on cleaning galvanized liner and bottle rack. Post by: Victor on September 09, 2018, 08:45:12 am I had my whole machine in parts chemical dipped and turned out nice, in toledo ohio.
Title: Re: Advice on cleaning galvanized liner and bottle rack. Post by: kdog on September 09, 2018, 08:52:49 am I had my hole machine in parts chemical dipped and turned out nice, in toledo ohio. I'm limited to more domestic options :blush: |