Pulver stop and go policeman

[cokemachinesandmore]

does anyone have any parts for this machine? while trying to straighten the rod that makes the policeman turn, I of course broke it.  it is 6 -32 thread on both ends and 2 90 degree bends 

[cokemachinesandmore]

trying to post a picture

[Eric]

Try Roger at www.crowriver.com
He may have it or know a collector who does. Good Luck!

[scalebowler]

If it is threaded on both ends could you use a threaded rod and just bend it where it needs to be bent?

[Chris]

I would hit up the local machine shop or check for a Fastenal store. Where I used to live in GA there was a company that would make bolts for you. They may could make you what you need.

[BrianB]

Post a pic when you get a chance with some dimensions.

[RetroMe]

You can try getting a piece of all thread and simply heat it up at the places you need to bend. Pretty easy with a bench vise and a piece of glavenized pipe to help with the radius bend. Can also use the pipe as a cheater bar to help with the bend.

[cokemachinesandmore]

Here is the pic of the rod, anyone work or have access to a machine shop. Just tell me how much I will need two of them.

[scalebowler]

I bet you could use threaded rod for that. Grainger has that size in a 3 foot length on their website. I think it is between 3 and 10 dollars depending on which one you get.

[cokemachinesandmore]

the length of the rod is about 4 inches total

[collecture]

I could do that real easy - without a machine shop.
Bend a rod with hammer and vice and then thread it or vice versa.
You can get threaded or un-threaded rod at Ace or Home Depot

[sodaworks]

Or you could just weld it back together. T

[cokemachinesandmore]

It snapped of at the thread. I think I may have found a source. I would like to thank everyone for their suggestions