Vendorlator VF-165 Coin Mech Swap

kraftworkz

Newbie

Offline

Posts: 46

« on: March 20, 2021, 11:38:52 am »

I'm trying to repair a Vendorlator VF-165 that has a Mars coin manager that is dead. I'm unable to find a manual or any info on what coin mech was originally installed in this machine.

I'm wondering if a Coinco 3000S series would work? Anybody have any inside info on this machine and if this would work? Much appreciated.


	Logged

Jim

Administrator
Soda Jerks

Offline

Posts: 5880

#1 Soda Jerk!

Re: Vendorlator VF-165 Coin Mech Swap

« Reply #1 on: March 20, 2021, 04:39:26 pm »

A little outside of my wheelhouse as it's too new for my knowledge-base...
Perhaps someone that has tinkered with newer machines will chime in...


	Logged

My six cents,

Jim

johnieG

Global Moderator
Soda Jerks

Offline

Posts: 5396

This is fine...everythings going to be OK....

Re: Vendorlator VF-165 Coin Mech Swap

« Reply #2 on: March 20, 2021, 09:36:51 pm »

pretty much any 120 volt/8-pin (Jones plug style) coinmech will work...

yeah that's the problem with MARS electronic mechs, once they glitch, their done. if you push the coin-eject buttons on the side of the change tubes & nothing happens ( no coins attempt to eject to the coin-return cup) then the logic board is toast. make sure you have power to begin with between the female Jones socket pins #1 & #2 & there should be a small red LED power indicator behind the coin-acceptor area. but never unplug the ribbon cable that connects the coin-acceptor to the main motherboard of the coinmech when the power is on... it will scramble the coin-detection circuit & it will reject all coins


« Last Edit: March 20, 2021, 10:01:07 pm by johnieG »	Logged

Spoon-feeding Newbies since 2001... Wink

Yeah..220,221 whatever it takes.
Remember, all it needs is a shot of Freon!
The Vendo V-83 is the '59 Edsel of the coke machine world. ;p
Spray painting does NOT restore a compressor
11 is louder than 10...
"Hope" is good, but it's not an action plan.

kraftworkz

Newbie

Offline

Posts: 46

Re: Vendorlator VF-165 Coin Mech Swap

« Reply #3 on: March 20, 2021, 09:55:40 pm »

Quote from: johnieG on March 20, 2021, 09:36:51 pm

pretty much any 120 volt/8-pin (Jones plug style) coinmech will work...

yeah that's the problem with MARS electronic mechs, once they glitch, their done.

Perfect. Thank you so much..


	Logged

Pages: [1] Go Up

« previous next »

	Author	Topic: Vendorlator VF-165 Coin Mech Swap (Read 3539 times)
0 Members and 1 Guest are viewing this topic.