Issues with door light on Vendo 110

[Slapshot42]

The ballast as mentioned is behind the door liner.  If you have to go that route once you pull the main door liner off you will see a brown block with wires,  etc.  If you need a new one SJW or Funtronics should have one.  It will be covered or around the insulation.

Mine is also bad on my 110.  I pulled my main door cover off to change out my coin.mech.  I fixed my
coin mech but lost motivation on the light for the time being. 

[collecture]

I pulled my main door cover off to change out my coin.mech.

Why? You can remove the mech easily without removing the liner.

[VMAXMAN]

The bottle door light on my Vendo 110 is having issues.  I'll press it and hold it down and it will turn on fine.  But, it only stays on for a few seconds to maybe 10-15 seconds as most and then just turns off and never comes back on (unless I hit the switch again).  Any ideas as to what potential problems I should be looking into before I take things apart?

mine did that and turned out to just be the lamp

[cokecolaman]

What kind of life are you getting out of the light bulb in the door...I'm changing mine about every year and a half.

[Slapshot42]

Not sure I know an easier way?  The mech rod went behind the liner and attatched to the linkage arm with a
pin inserted.




Obviously missed something.....

Jared

[MoonDawg]

      That is what this plate is for.

[Slapshot42]

Well, i guess i know for next time.