|
Title: Mag30b Bill Validator help... Post by: dustintinsley on April 05, 2010, 04:22:28 pm I just purchased a Mag30B off of eBay. When it came in, it didn't have any type of harness with it. So, now, I do not know how to plug this up to use it. I have a CoinCo 9360 coin mech. What type of harness is required to plug into the Mag30b? I have looked in the service manuals, and while I'm sure it is there, I didn't see it. So, what type of harness and where is a good place to pick one up? Thanks in advance.
Title: Re: Mag30b Bill Validator help... Post by: Creighton on April 05, 2010, 05:34:19 pm Welcome to the board! May be a bit of delay in reponse to your question. Most here work with the older machines.
Creighton Title: Re: Mag30b Bill Validator help... Post by: dustintinsley on April 05, 2010, 05:47:50 pm creighton: no of anywhere i could go for assistance?
Title: Re: Mag30b Bill Validator help... Post by: scalebowler on April 08, 2010, 10:30:45 am Here are manuals for a lot of coincos products. Maybe one of them tells you how to hook it up? http://www.coinco.com/coin/faq/servicemanual.asp#bill
|