|
Title: s.s. bezel on ideal slider Post by: r500 on March 20, 2012, 08:50:41 pm Has anyone removed the stainless steel bezel on a ideal slider and if so how did you get it off ?????????
Title: Re: s.s. bezel on ideal slider Post by: Slider-Bob on March 20, 2012, 09:32:01 pm Do you mean on the coin box?
Title: Re: s.s. bezel on ideal slider Post by: MoonDawg on March 21, 2012, 07:26:43 am If you mean the SS trim across the front / top...........no! It is welded on.
Title: Re: s.s. bezel on ideal slider Post by: Pat Pixley on March 21, 2012, 09:50:31 am Are you talking about the stainless steel piece right in front of the lid ? If that is what your talking about then yes
(see Attached photo) (http://i214.photobucket.com/albums/cc125/Vernors131/100_0432.jpg) Title: Re: s.s. bezel on ideal slider Post by: r500 on March 21, 2012, 07:17:32 pm The S.S. across the front at the top is it only welded where the screw holes are? ?????????
Title: Re: s.s. bezel on ideal slider Post by: Pat Pixley on March 21, 2012, 07:44:01 pm The few that I've played with were not welded in just bolted in.
Title: Re: s.s. bezel on ideal slider Post by: cohammer on March 21, 2012, 08:51:30 pm are you sure they are not rivet's
Title: Re: s.s. bezel on ideal slider Post by: Funtronics on March 22, 2012, 06:24:33 am We sell new ones that go right over top the old ones, and are held in with the screws that hold your rubber in. I think the originals are welded in and would be very hard to get off. You can go to our web sight www.fun-tronicsllc.com and check them out under the Ideal 55 section.
Title: Re: s.s. bezel on ideal slider Post by: SIGNGUY on March 22, 2012, 09:34:00 am I had a old shell of a slider cooler they me and my body guy decided to see how hard it would be to dismantle.. and lets just say.. DoN"T you'll create more of a headache and mess trying to remove it and then trying to weld in a new peice... it is welded in in many places and you littlerly have to cut it outand it hacks up the body..
use the one that funtroncs sells , it's easy and looks great! Title: Re: s.s. bezel on ideal slider Post by: Slider-Bob on March 22, 2012, 10:10:02 am I currently have an Ideal 55 Pepsi slider that I'm parting out, and the 2 foot long piece at the top/front came right out.
It was not welded on, and was easily removed. Title: Re: s.s. bezel on ideal slider Post by: MoonDawg on March 22, 2012, 10:16:44 am How was it held in Bob?
Title: Re: s.s. bezel on ideal slider Post by: Slider-Bob on March 22, 2012, 07:49:16 pm It was just snapped in there. No nut/bolt, no rivets. It may have had some minor adhesive on it, but I removed it with my fingers kinda prying/lifting at the same time. I have it in my shed and can take pics of it to verify.
|