VMC 81 found on Craigs list tonight!

[mdunn]

I wrote you a PM, I need everything to make it vend once again.

Mike

[mdunn]

Ok guys, new pictures and better shots. What am i missing to make it vend with a coin?

[coke_and_stuff]

I probably have everything that you need with the exception of the Vend Cam that can be bought brand new. I can start sorting it all out of needed. Let me know

Joey

[mdunn]

[mdunn]

[mdunn]

[mdunn]

Yes i got the light working, Thanks Mike!

[mdunn]

[mdunn]

[SIGNGUY]

From what I can see you need, and sounds like Joey might have some parts, but Almost everything is reproduced except for a few small parts in the bottle stack..
Main Door, missing actuator linkage that will connect to the coin mech and run inside the door to the vend cam.
Missing Coin mech, Tom can hook you up there

One big problem that I can see.. is that your coin door is all sealed up with some bondo and a plate the blocks where the Vend handle from the coin mech will pass through.. so your nice little coke bottle decal on the front door is going to get messed up. and also the coin door as you'l have to cut out that opening again and remove all the bondo, and I can bet you they smashed in the little "Lip" around that opening when they bondo'd it all up.. so that main coin door is going to have to be redone.

The other issue, unless you can find used parts, is on the bottom of your bottle stack, you are missing all the mechanics that work with the vend cylindar and what only allows one bottle to be vended at one time,,, It's very difficult to describe.. i'll shoot a photo.. but these small little parts are not reproduced, except for the vend cylinder.. so that will be tough.

outside of that, most parts should be able to be found..

Good luck!