U Select parts needed...

[davethebirdman]

Thanks for looking....

Dave

[Basementgeek]

What does the back of this lock bold into.

I have some older Ace locks that the back is 5x9mm rectangle, not square.  It uses a stud and nut to secure locking bar, not a bolt  Maybe modify the lock bar a little to accommodate at rectangle hole not a square one.

BG

[SIGNGUY]

I just bought anothe Uselect and hope it has the original lock and can take more photos of that area , or Dave, can you shoot the back of the lock, the square part that goes into the locking bar.. that is the issue, finding something that same size.

[collecture]

I am pretty sure the lock you guys need is the same as used on the Standard Coin Changers (pictured below), which can be obtained fairly inexpensively.
I'll try to get a picture of the lock for you later today.

[davethebirdman]

Chaps

Have managed to fire off a couple more pictures on a close up... of the lock... Can't take a picture of the locking bar because I don't have the machine here at the moment... Hope it helps...

Dave

[bubba]

Dave... have a look at the locks on this page... If the circular lock measures the same, lemme now...

http://www.mcmaster.com/ctlg/DisplCtlgPage.aspx?ReqTyp=CATALOG&CtlgPgNbr=2913&RelatedCtlgPgs=2920,2919,2916,2912,2921,2913,2914,2917,2918,2915&term=Cabinet%20Locks&ScreenWidth=1024&McMMainWidth=814&ToolsetID=ToolMultiPageNav&ToolsetAct=&sesnextrep=104214664151959

[SIGNGUY]

Speaking for us U-Select Owners.. it's not that we can't find a lock, it's that the locks that are readily available have a larger size "Square" end than what is needed to fit into the locking bar. All of these have square ends, but are generally larger than what will fit , best bet is to grind down.. I'm working on one this weekend,, we'll see how it turns out.