Ideal Slider - Wiring

[BryanH]

When I started tearing mine apart I had a similar question... Couldn't find the post but here's the diagram I drew.

[MoonDawg]

Mr Z.    I think the answer you are  looking
for is "crimp terminals" They are small #8 rings
that crimp to the end of your wire. The screw
through them.
      Duchon, may I give you and the group a
word of advice?  The power cord going ito the
wall outlet has a VERY high chance of getting
snagged while moving as we all know. A small
clamp is normally installed at the factory and
screwed into the machine. This clamp absorbs
the strain instead of the j-box.

[ZMonet]

Thanks everyone.  I'm off to Radio Shack today to pick up the crimp terminals

[aspbear1]

I dont know if this is the answer for the extra wire but some of the Ideal 85's have a switch on the lid that shuts the compressor down if the lid is opened.  The Nesbitt's that I am working on right now has that type of switch.   It is spring loaded and located in the lid hinge.