Ideal 55 troubleshooting question

<< < (2/2)

johnieG:
Don't kow since you cant give me any pressure readings, just guessing at this point, it's a closed loop/sealed system if there were a leak, it will continue until it's internal pressure reaches equalization with atmosphere. after sitting for so long, you may have scaly rust on the condensers steel high side line fed from the compressor, when you fired it up, you may have induced a leak at that point. ( this is quite common on these machines)   or there may be no leak at all & just loose lines, other that telling me that it "cold" at the top, whats the actual air temperature in the bottle compartment?

Again, you have to test the system & stop guessing because it wont fix the machine.

Navigation

[0] Message Index

[*] Previous page