Temperature control

<< < (2/2)

johnieG:
Rotate the knob fully counter-clockwise until it clicks “off” take note of where the “Off”  position is at ( 6-o’clock, 9-o’clock, etc)  put a reference mark on the chassis / metal flange with a sharpie or scratch it onto the metal next to the “Off” mark on the knob, this is your index point, Now turn the knob back clockwise until the #3 aligns with the new mark, this is s typical start point for a machine, normally there is an embossed mark, line  or a notch on the metal surrounding the knob somewhere. Or even a dot of paint

Paul:
johnieG

Thanks. Recommended setting?

Paul

johnieG:
Like I said, 3 is typically “normal “

Navigation

[0] Message Index

[*] Previous page