Quickcold Lower End Cap and Frame Needed.

[ajf5577]

Does anyone have a junk standard or master with an end that has "Ice Cold" ? I just need the lower half with the words on it. The one that I have has damage. Doesn't matter what brand of soda. I Also need the lower frame. Condition needs to be good enough to restore.

[ld26]

Sorry don't have a donor side but before you get one measure the width of that side panel, it should be 23 inches wide to match a standard size side panel, just to be sure,  I usually know it will be good by seeing the 5 grooves on the bottom of the side panel, from the picture I can't tell

[Eric]

No extras here either... If you're going to make it a standard or junior it'll need these 5 indents along the bottom like ld56 posted.
If it has 4 it's a larger style and would be too wide for these models.

All your embossing  looks good is the ICE COLD bad? Could always cut all the embossing out and place on a generic
cooler if you find one that doesn't have the ICE COLD...

[ajf5577]

Good points. I will have to get it out and look at it again.
The " ice cold" is good. Just has that tear on the edge, and the bottom corner is a little soft. I'm sure a good body man can fix the tear.