sledworks
|
|
« on: January 03, 2013, 05:27:08 pm » |
|
Just noticed my Cavalier 33 evaporator motor is not running. It was the other day. I had someone check power and voltage is getting to it. (Just had new wiring harness installed.)
A lot of frost has formed along the refrigeration line and coke bottles at bottom of machine are freezing.
1. What does the evaporator motor/fan do?
2. Who sells replacement ones for my model?
Thanks,
Jimmy
|
|
|
Logged
|
Jimmy Rosen Old Sled Works Duncannon, PA 17020 www.sledworks.comFacebook:Old Sled Works Vendo 23,39,44,110 Vendolator 27 Cavalier 33, CS64 Ideal 55B Pepsi LaCrosse 7up EC81 Rowe Cig (2), Cigar, Gum (5) Stoner Senior, Jr, Cafe, Gum (2) Apco CoffeeShoppe Jr 1947 Popcorn Sez Other Cig
|
|
|
MoonDawg
|
|
« Reply #1 on: January 03, 2013, 05:48:08 pm » |
|
The evaporator fan motor is to keep frost from forming along the refrigeration lines. Moves that cold air to keep all bottles the same temp. The suppliers on this site should have your fan motor.
|
|
|
Logged
|
Glen
|
|
|
sledworks
|
|
« Reply #2 on: January 03, 2013, 08:53:09 pm » |
|
The evaporator fan motor is to keep frost from forming along the refrigeration lines. Moves that cold air to keep all bottles the same temp. The suppliers on this site should have your fan motor. Thanks Glen. Anxious to get this machine working right for the public to use. Put some shims inside bottle compartment so newer bottles will stack properly.
|
|
|
Logged
|
Jimmy Rosen Old Sled Works Duncannon, PA 17020 www.sledworks.comFacebook:Old Sled Works Vendo 23,39,44,110 Vendolator 27 Cavalier 33, CS64 Ideal 55B Pepsi LaCrosse 7up EC81 Rowe Cig (2), Cigar, Gum (5) Stoner Senior, Jr, Cafe, Gum (2) Apco CoffeeShoppe Jr 1947 Popcorn Sez Other Cig
|
|
|
collecture
|
|
« Reply #3 on: January 03, 2013, 10:32:34 pm » |
|
Don't know if that style motor is available through suppliers. It is not your normal evap fan motor. Might be difficult to locate. I think something could be found though.
|
|
|
Logged
|
Cav 27, 33, CS-55E-2, 72 S-48 DP Ideal CC 35, Barq's 55 1930s DP Counter Cooler Vendo Coin Changers (ea. style - orig w/ stand) Vendo Junior (rest.), 23 Deluxe, 39D, 44, 56RT, 80SS, 81A (orig), 81D, 6 C.V. VMC 27, 27A, 81D DP, 110 DP Westy WC-42-T, WC-44SK, WD-5(2), WB60 Victor C-14
|
|
|
sledworks
|
|
« Reply #4 on: January 04, 2013, 06:25:40 pm » |
|
Here's image of motor. I have a few feelers out. If I go to Granger's, what specs do i tell them? The manual only says "two wire shaded pole type".
|
|
|
Logged
|
Jimmy Rosen Old Sled Works Duncannon, PA 17020 www.sledworks.comFacebook:Old Sled Works Vendo 23,39,44,110 Vendolator 27 Cavalier 33, CS64 Ideal 55B Pepsi LaCrosse 7up EC81 Rowe Cig (2), Cigar, Gum (5) Stoner Senior, Jr, Cafe, Gum (2) Apco CoffeeShoppe Jr 1947 Popcorn Sez Other Cig
|
|
|
johnieG
|
|
« Reply #5 on: January 04, 2013, 06:51:20 pm » |
|
It looks just like the guts to my bathroom's exhaust fan, I'd bring it along for the ride to Graingers. other than the squirrel-cage blower, it's identical to a Choice Vend or a Glasco sliders evap' motor.
helpful hint no. 136, this type of motor's rotation can be easily reversed by removing the armatures ( rotating core) end bearing plates & flipping it ( the armature) over 180-degrees to the opposite side of the field coils. & reassembling it, just be sure not to over torque the thru-bolts or you'll lock the rotor in place, or warp the bearings end-caps to the point where may cause the core to rub up against the field coils opening.
|
|
« Last Edit: June 20, 2020, 11:55:26 am by johnieG »
|
Logged
|
Spoon-feeding Newbies since 2001... Yeah..220,221 whatever it takes. Remember, all it needs is a shot of Freon! The Vendo V-83 is the '59 Edsel of the coke machine world. ;p Spray painting does NOT restore a compressor 11 is louder than 10... "Hope" is good, but it's not an action plan.
|
|
|
sledworks
|
|
« Reply #6 on: January 04, 2013, 07:19:14 pm » |
|
other than the squirrel-cage blower, it's identical to a Choice Vend or a Glasco sliders evap' motor.
Thanks JohnieG. Should I try this one from one of the suppliers here? http://www.fun-tronicsllc.com/index.php?crn=233&rn=1367&action=show_detail
|
|
|
Logged
|
Jimmy Rosen Old Sled Works Duncannon, PA 17020 www.sledworks.comFacebook:Old Sled Works Vendo 23,39,44,110 Vendolator 27 Cavalier 33, CS64 Ideal 55B Pepsi LaCrosse 7up EC81 Rowe Cig (2), Cigar, Gum (5) Stoner Senior, Jr, Cafe, Gum (2) Apco CoffeeShoppe Jr 1947 Popcorn Sez Other Cig
|
|
|
johnieG
|
|
« Reply #7 on: January 04, 2013, 07:30:23 pm » |
|
I'm not 100% sure if your current motor is even original to your V33, check out the replacement motor shown for your specific model on the same page.
|
|
|
Logged
|
Spoon-feeding Newbies since 2001... Yeah..220,221 whatever it takes. Remember, all it needs is a shot of Freon! The Vendo V-83 is the '59 Edsel of the coke machine world. ;p Spray painting does NOT restore a compressor 11 is louder than 10... "Hope" is good, but it's not an action plan.
|
|
|
sledworks
|
|
« Reply #8 on: January 04, 2013, 08:02:41 pm » |
|
I'm not 100% sure if your current motor is even original to your V33, check out the replacement motor shown for your specific model on the same page.
That's for a VMC 33. I have a Cavalier.
|
|
|
Logged
|
Jimmy Rosen Old Sled Works Duncannon, PA 17020 www.sledworks.comFacebook:Old Sled Works Vendo 23,39,44,110 Vendolator 27 Cavalier 33, CS64 Ideal 55B Pepsi LaCrosse 7up EC81 Rowe Cig (2), Cigar, Gum (5) Stoner Senior, Jr, Cafe, Gum (2) Apco CoffeeShoppe Jr 1947 Popcorn Sez Other Cig
|
|
|
briandr1
|
|
« Reply #9 on: January 04, 2013, 08:52:52 pm » |
|
You can try Johnstone suppy if you have one where you live Ive had good luck with them in the past getting condensor and evap motors. Seems like everytime I go to grainger I stand there for an hour and they give me the wrong motor. Take the old one with you.
|
|
|
Logged
|
selectivend 64 sa 2 cavalier 96 1975 bally hi deal em pinball machine 1920 wate and fate penny scale
|
|
|
|