New Years Project - Vendo Coin Changer Pole Mounting Plate

[Ltransam]

       I also Would nterested in one .Is It Just the  the Back Plate ? Including The Pole & Base ? Because Those are Harder to Find .

[Jim]

Just to clarify, this will be for the "pole mount back plate"; I may have a complete setup for sale next month as pictured below...

AS for the slight changes, the first will be the way the pole guides/supports will be milled square to the plate whereas the original has a slight curve; the other will be how deep the pole guides/supports are... Meaning an original is approx. 3/4" high from the back plate; the reproduction would be approx. 5/8" high. This is due to billet aluminum stock sizes. Functionality will not be affected from these slight changes.

[Ltransam]

 AHHHH !!! 

      Ok  !! 1 Question  Is the Orginial Stand Base The same Size as the LollyPop & PoliceMan Base ??

[collecture]

An original stand is on the right.
The pole used a straight thread (not tapered like plumbing pipe) and was threaded through the base with a nut on the underside. Then the base could be bolted to the ground through the holes on each side.
The Coca Cola stand I fabricated using plumbing pipe.
I have original backing plates on both stands

[Jim]

Thanks for the Photos Tom ! ! !

Hope that clarifies the difference between bases/poles...

And just for the record, I'm only looking at reproducing the back plate the pole/coin changer mount to. In Tom's photo, you can see the outer edge around the coin changer...