SMC Discussion Areas
November 04, 2024, 04:12:28 pm
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News
:
Home
Help
Login
Register
SMC Discussion Areas
>
Soda Machines, Coolers & Dispensers
>
Post 60's Machines & Coolers
(Moderators:
johnieG
,
Jim
) >
cav. 96 light ballast
Pages: [
1
]
Go Down
« previous
next »
Print
Author
Topic: cav. 96 light ballast (Read 3075 times)
0 Members and 1 Guest are viewing this topic.
briandr1
25 Cent Member
Offline
Posts: 459
cav. 96 light ballast
«
on:
January 15, 2011, 02:00:37 pm »
I was wondering do you have to take the inner door liner off to get to the ballast on a cav 96 sure seems that way
Logged
selectivend 64 sa
2 cavalier 96
1975 bally hi deal em pinball machine
1920 wate and fate penny scale
JKyleW
Guest
Re: cav. 96 light ballast
«
Reply #1 on:
April 26, 2011, 10:56:37 am »
Not sure if you resolved this, but for my CSS-96-F, the ballasts and bulbs can be accessed without removing the door liner. It's been a looonnng time since I did this, but I believe there a couple of screws behind the top of the door to unscrew but then you should be able to carefully pry the light frame out of the housing from the front using a knife or other tool. Just be careful not to damage the rubber gasket.
Kyle
Logged
briandr1
25 Cent Member
Offline
Posts: 459
Re: cav. 96 light ballast
«
Reply #2 on:
April 26, 2011, 12:44:40 pm »
yea ive done that the ballasts must be behiend the panel where the lights mount the starters are under there there are holes in the panel to access those. the ballasts seem to be under that pannel which is rivited on maybee I have to drill out the rivits I dont know. thanks
Logged
selectivend 64 sa
2 cavalier 96
1975 bally hi deal em pinball machine
1920 wate and fate penny scale
JKyleW
Guest
Re: cav. 96 light ballast
«
Reply #3 on:
April 26, 2011, 04:53:15 pm »
Yeah, I think you're right -you do have to remove the door cover. There are screws on the back side of the door that the metal panel with the lights/ballasts are mounted to. No drilling of rivets necessary though. It's a pain because of all the screws and the weatherstripping covering them makes the screwheads hard to reach. Good luck!
Kyle
Logged
Pages: [
1
]
Go Up
Print
« previous
next »
Jump to:
Please select a destination:
-----------------------------
The Coin Return
-----------------------------
=> Soda-Machines.Com News
=> Other Coin-Op's
=> General Chit Chat
=> Estimated Values
=> Tutorials & Tips
-----------------------------
Soda Machines, Coolers & Dispensers
-----------------------------
=> Pre 60's Machines & Coolers
=> Post 60's Machines & Coolers
=> Picnic Coolers
=> Syrup Dispensers
-----------------------------
Trouble-Shooting
-----------------------------
=> Coin Mechanisms
=> Refrigeration
=> Vending Mechanisms
-----------------------------
Restorations
-----------------------------
=> General
=> Refinishing
-----------------------------
The Vending Rack
-----------------------------
=> Swap Meet Area
Loading...