Hi guys I'm about to take out the bottle racks (vending assembly) in a VMC 56 square top to give everything a good clean.
As a real nooby is there anything I should be careful of when doing this apart from turning off the power!

Appreciate any words of wisdom

RT

Thanks Bubba, shall follow your advice.
I took out one screw last night that had a bit of rust around it, Now i've taken it out it does not go back just spins in free space?? (I think the rust may be more than on the surface.

It seems to me the refrigeration unit and floor pan would have to come out so I can get to the rust - unless there is some quick fix I could try with a rust converter?


Is taking the refrifgeration unit out something a novice could do?
Also does the floor pan come up very easily?
(is that ordinary putty in the corners or some special adhesive?)

Sorry for so many questions )

In your 'rust+pan3' pic, I am not so sure that is bad rust. Vendo, VMC, etc put down a putty type substance around the bottom edge of the tub. To me, that is what it looks like in your pic.

Taking out the refrigeration unit is not that hard - maybe 8 screws/bolts!
Make sure you have something to set the evap assembly on so you do not bend the refrigerant lines. You want it to resemble the way it is inside the machine.
1. Remove the two screws on the line cover and remove it.
2. Remove the 4 screws holding the evaporator assembly.
3. Remove the two bolts holding the compressor plate down.
4. Slide the whole unit out.
While you have it out, go ahead and install new fans and a t-stat for it...you'll be glad you did!

Yes - it should scrape right off.
I am not sure what you might have available to you in Australia, but a some kind of window putty should work. I use an electrical putty called duct seal.

As far as the screw, unless you are restoring or there is bad rust, just replace with a slightly larger screw.

I have also used clear silicone caulk before and it worked great.