Menu Content/Inhalt
SMC Discussion Areas
November 22, 2008, 09:27:06 am *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News:
 
   Home   Help Login Register  
Pages: [1]   Go Down
« previous next »
  Print  
Author Topic: Choice-vend parts  (Read 181 times)
0 Members and 1 Guest are viewing this topic.
Guest
« on: June 30, 2003, 12:27:00 pm »
I have a choice vend 142 that has a bad "vend limit switch". this is a switch that sit under the auger to start and stop it.

Does any one know were I can get a replacement and how much it will cost?

Thanks
Logged
johnieG
Global Moderator
Soda Jerks
*****
Offline Offline

Posts: 2444
« Reply #1 on: June 30, 2003, 10:48:43 pm »
Yes...Me!  '<img'>  (shamless plug) I have some very good used motor/helix/gear assy's. To be sure It's apples & apples can you show a picture of your assembly? I've wired up a tester to test & set up these vend motor/helix gears to vend bottles or cans, I'm asking $50.00 +shipping for the complete unit, which will give you: A spare motor/switch, a set of four gears(gray "delron"-plastic),& the augers(black nylon) too,(one each of a front,mid-front,mid-rear & rear) & of course the frame they come on, so you can just swap out the whole assy if you wish. I have a printed view of the helix/gear setup too. a nice package deal... let me know if you're interested...JohnieG
Logged
Yea, 220...221, whatever it takes.
Guest
« Reply #2 on: July 01, 2003, 08:02:07 pm »
The one you have is diffrent mine has 4 selections and yours seems to have 5.
I think I may have found the switch at a local eletrical supply store. If it does not work I may want to buy your's for parts.

I will have the switch early next week. I will let you know what happens.
Logged
johnieG
Global Moderator
Soda Jerks
*****
Offline Offline

Posts: 2444
« Reply #3 on: July 01, 2003, 10:58:58 pm »
No problem James, the helix/gear assemblys are the same for both machines, and are interchangable, each column has it's own gear/motor assembly that drops out from the bottom (or you can just remove the whole lower vend unit & do it on a work bench) they remove with one 1/4 drive screw & unplug from the rear underneth the vend unit after removing the augers, (by removing there top strap) it drops out by pushing it slightly backwards & down & out the front...inspect the gear nearest the motors drive worm-gear closly & make SURE that there's no striping going on (usally caused by a can-jam)
you can find a switch locally with some digging but the gears aren't avalible anymore.  '<img'>
Logged
Yea, 220...221, whatever it takes.
Pages: [1]   Go Up
  Print  
« previous next »
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.7 | SMF © 2006-2008, Simple Machines LLC
Joomla Bridge by JoomlaHacks.com 		Valid XHTML 1.0! Valid CSS!