Menu Content/Inhalt
Home arrow Discussion Areas arrow Trouble-Shootingarrow Coin Mechanismsarrow Coinco 9800b - where do i get a new c.r.e.m.?
SMC Discussion Areas
December 02, 2008, 05:32:12 pm *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News:
 
   Home   Help Login Register  
Pages: [1]   Go Down
« previous next »
  Print  
Author Topic: Coinco 9800b - where do i get a new c.r.e.m.?  (Read 208 times)
0 Members and 1 Guest are viewing this topic.
Guest
« on: March 21, 2005, 04:28:38 pm »
Does anyone know where I can get parts for my Coinco S75-9800B.  I think I need new C.R.E.M.s and maybe a new transformer.

Thanks.
Logged
johnieG
Global Moderator
Soda Jerks
*****
Offline Offline

Posts: 2449
« Reply #1 on: March 21, 2005, 05:10:53 pm »
Well I doubt anybody has any N.O.S. (New Old Stock) CREMS lying around, so you'll be in the market for a parts unit, so you can either replace them, or remove them & bypass the wiring for them. (which is OK for home use) as for the transformer, they usually don't go bad, they are easy enough to remove it from the case with two screws & four wire-connectors & bench test...120 volts AC goes in, & 12 volts AC comes out ( your voltmeter will read a little higher , around 16volts AC, this is normal.) if you don't have an Digital Volt meter or simular device, a 12 volt lamp will do nicely for a go-no-go test....

My reasoning is , if it's for home use, why reject coins anyway?, or I can repair it for you if you wish, ( email me at jg59chevy@hotmail.com) I assume that you mean that the CREMS aren't "on" (pulled in) & the 'mech is rejecting all coins?
Logged
Yea, 220...221, whatever it takes.
Guest
« Reply #2 on: March 21, 2005, 05:21:46 pm »
Thanks, I can check the transformer.  On the CREM's, I thought maybe I could remove the spring and just tape them down.  Will that work or is there some wiring I need to re-route?
Logged
johnieG
Global Moderator
Soda Jerks
*****
Offline Offline

Posts: 2449
« Reply #3 on: March 21, 2005, 11:22:44 pm »
Quote (Flash @ Mar. 21 2005,5:21)
Thanks, I can check the transformer.  On the CREM's, I thought maybe I could remove the spring and just tape them down.  Will that work or is there some wiring I need to re-route?

Depends if one or both of them are burned "open" , if they are both non-functioning, then you may have an electrical problem from your vending switch down by the vending relay(have you been working on it lately?) , or a circut board problem, you can either tape them down ( no need to remove the spring, or lift the spring & remove the amature(s) by sliding them up & off (carefully)...hope this helps...let us know how it goes. JohnieG  ':drinkers:'
Logged
Yea, 220...221, whatever it takes.
Pages: [1]   Go Up
  Print  
« previous next »
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.7 | SMF © 2006-2008, Simple Machines LLC
Joomla Bridge by JoomlaHacks.com 		Valid XHTML 1.0! Valid CSS!